Skip to content
FANUC Robots
Read more about FANUC Robots

robotic-board-handling

MCRI Robotic Case Study

Robotic Board Handling Case Study


Customer

Company Overcomes Manpower Problems with New Automated Stacking System

Industry:

Building and Construction Materials Manufacturing

Customer:

This customer is a building products company that provides support to general contractors, architects, engineers and governmental agencies


Challenge

robotic board handling

An international building products company that provides support to general contractors, architects, engineers and governmental agencies needed an automated way to stack flat and tapered boards to both increase speed and alleviate large turnover in manpower.

Before working with Motion Controls Robotics, the company had no automation. Employees manually lifted and stacked the boards, often leading to injuries. The company also had a high employee turnover rate and used some temporary staff. In addition, the stacks created manually were often uneven, making it difficult to keep the products from leaning.


Solution

Motion Controls Robotics recommended a system using a robot with a vacuum-powered end-of-arm tool to position, square and pick up the boards from the existing equipment. The robot lifts the board and sets it onto a chain conveyor, rotating every other board. At a pre-determined count, the stacks are sent out to handling conveyors that move them to down-line equipment.building and construction

Motion Controls Robotics installed, tested and provided training and support during the startup to familiarize the associates on how to operate the equipment. Motion Controls Robotics technicians directly supervised start-up, eventually turning over operation to the newly trained employees.


Details

The robotic board handling system used two Fanuc M-410iB robots, HandlingTool software and custom written software to handle the robot motion. Peripheral equipment included an Allen Bradley PLC, and PanelView Plus HMI.


Result

According to the company, this system close-up-board-handlingallowed for three fewer employees per shift. By decreasing the number of employees, the company reduced manpower turnover and injuries. Straighter and neater stacks could not be achieved using the original manual system. With the automated system the robots can stack precisely and also rotate tapered boards every other part which allows for more even and straighter stacks.

With the robotic board handling system, the company increased production an average of 20-30 percent and as high as 60 percent on some products.

This robotic stacking system has run for nearly six years in one plant and more than a year in the latest plant to install the system. The robotic stacking system has been installed in six plants, with orders placed for three additional systems.


Read more about the Building and Construction Industry robot cells

Robotic Stacking of Flat Panels Video

Testimonial

Board Handling

Read testimonials to see how this automation system has helped other manufacturers.

Back To Top